- Item: Speaker Refurbish
- Type: Bose 901 Series III
- Posted: 4 August 2010
- Builder: Wardsweb
- Country: United States
- Comments: 2
Refoam
I started with a pair of 901 III that were intact but tired. The drivers all needed new foam. I removed all the drivers and cleaned all the old foam off.
This left a nice clean surface for the new cloth edging. I went with the newer "V-Roll" cloth surround. I first glued the surround to the underside of the cone. After letting that dry, I glued the outside edge to the frame.
The cabinets needed some attention too.
So some hand sanding and a few coats of DEFT wood finish.
This left a nice clean surface for the new cloth edging. I went with the newer "V-Roll" cloth surround. I first glued the surround to the underside of the cone. After letting that dry, I glued the outside edge to the frame.
The cabinets needed some attention too.
So some hand sanding and a few coats of DEFT wood finish.
Comments
- yoey
- 14 August 2014 at 12:15PM
- Great job, I wonder, What is the ohms of each driver and how are connected?
- Chris
- 25 October 2014 at 01:38AM
- Yoey
These ARE NOT mine. But, provided they're holding nominal specs, SHOULD e in the neighborhood of about .9 Ohms Per driver(wired in series)