- Item: original teres project bearing and motor
- Type: teres project tt revisted
- Posted: 16 January 2013
- Builder: berndt
- Country: United States
- Comments: 0
Edwins teres
I built this teres plinth out of 1.5" thick aluminum plate. This plate is bolted to a cast steel disk and sandwiches a thick rubber ring. I also spun up an aluminum platter to replace the original acrylic lamination. Sme tonearm.
Working on a new motor pod for this bad boy right now.
Working on a new motor pod for this bad boy right now.
Comments
No comments. Leave your comment below.