I built this speakers a few years ago with mostly Dynaudio drivers.
They were available as kits from Dynaudio at late 90's, but I have used of some finer qualities than original drivers. And with my own twist of cabinets with curved sides.
The speaker drivers are not commercially available anymore, and it has taken me several years to find unused or sparingly used drivers, but was well worth the wait.
The cabinets are made of oak veneer on 30mm's MDF and solid oak.

Comments

• klura01
• 22 February 2013 at 04:52PM
• Looks great. Please tell us something about the sound character and with what kind of amps you listen.
  Best wishes
  Rainer
  It is possible to become the plan from the front and rear speakers?
  

• Mixon1
• 23 February 2013 at 12:14AM
• Thanks!
  They sounds really close to the typical "Dynaudiosound!" neutral, detailed and distinctly.
  For now I use a old Nad 208, but soon I will use my DIY Aleph 1.2 when they are finished.
  Sorry, I do not quite understand the last lines, you mean drawings?
  Regards, Michael
  

• klura01
• 24 February 2013 at 09:30AM
• Sorry for the missunderstanding, yes I mean the drawings for the speakers, thanks a lot

• Mixon1
• 24 February 2013 at 11:35AM
• Look down at:
  http://www.gattiweb.com/dynaudio.html
  
  You will find Finale and Xennon3 drawing, in original.
  
  I also have Xennon2, and Twynn as center.
  
  I do have drawings of all my speakers in Solid Works Cad's,(cabinets), but I have recalculate all crossovers, and volume for my finer drivers, so not much is like the original ones.
  
  Regards, Michael

• termit
• 29 April 2013 at 09:39AM
• Hello send the crossover to the center channel and on the front salcovruslan@gmail.com thank you with respect, Ruslan.

• termit
• 29 April 2013 at 09:51AM
• And if you can korpusov.Spasibo drawings

• MajorTendonitis
• 2 December 2018 at 12:03AM
• One of my favourite builds here . Bet they sound as good as they look.
  I’m pretty intimidated by veneer

• Rob
• 2 April 2023 at 03:47AM
• Mixon1 ,
  I bought the Finale kit in 1998 and stopped with the rough panels cuts. Back then, I have my distributor replace the d260 with t-330 and the d52af with M560. Still all in boxes.
  I have to adjust the holes and ****ing with driver changes.
  Are you still around for some questions on your finish ?
  Nice Job on yours!
  thanks
  rob